Blog

News Center

Pulse heating principle: Due to the special design of the welding head surface, the resistance of the welding surface is very small, and the current will pass through the section with the smallest resistance. By continuously changing the voltage and adjusting the current level, the welding head is made to heat up rapidly.

View Details

Objective: To analyze the hazards of cold press machines during operation, standardize safe operating procedures and precautions, and prevent accidents.

View Details

Refrigerated air dryer, also known as a refrigerated compressor. The amount of water vapor in compressed air is determined by the temperature of the compressed air: while keeping the compressed air pressure basically unchanged, reducing the temperature of the compressed air can reduce the water vapor content in the compressed air, and the excess water vapor will condense into liquid. Refrigerated air dryers (refrigerated dryers) use this principle to dry compressed air using refrigeration technology.

View Details

Therefore, refrigeration dryers (freeze dryers) have refrigeration systems. In the refrigeration system of a refrigeration dryer, the evaporator is a device that delivers cold, where the refrigerant absorbs heat from the compressed air to achieve dehydration and drying.

View Details

Cold presses are divided into screw cold presses and hydraulic cold presses. Screw cold presses have turbines, require long-term maintenance, and are prone to damage. Hydraulic cold presses are not prone to oil leaks, do not require frequent maintenance, and have higher work efficiency.

View Details

A hot press is a device that heats two pre-tinned parts with flux to a temperature sufficient to melt and flow the solder, forming a permanent electrical and mechanical connection between the parts and the solder after solidification.

View Details